08

2022

-

04

Everyone has a more and more specific understanding of the help of trailer ABS for driving safety

Author:


Everyone has a more and more specific understanding of the help of trailer ABS for driving safety. It can prevent side slip caused by wheel locking during emergency braking, effectively improve the active safety of the vehicle, reduce Tire wear, etc.
Next, I will briefly talk about the installation of ABS on trailers. When it comes to the ABS system, everyone must be familiar with it. Taking the WABCO trailer ABS system installed on T7H as an example, it mainly consists of trailer ABS controller, wheel speed sensor, ABS system power cord, etc. The WABCO ABS controller and the regulator solenoid valve are integrated.

The ABS system installed on the Kayou trailer this time is WABCO 4S/2M Trailer ABS. The so-called 4S refers to four sensors. When the WABCO ABS system is installed this time, the four sensors are installed on the first axis and the third axis respectively, and no sensors are installed on the second axis.

Then install the ABS system on the trailer, some card friends may think this is quite complicated. It's actually not that difficult. Next, I will briefly talk about the installation process of trailer ABS in five steps.

Step 1: Installation of the ring gear
The ring gear cooperates with the sensor to generate an induced voltage signal, which is transmitted to the electronic control unit ECU. The electronic control unit judges the degree of wheel locking according to the wheel speed signal and then adjusts the wheel braking force. Therefore, the correct installation of the ring gear is an important guarantee for the effective work of ABS.
The ring gear is mounted on the hub and rotates as the wheel turns. When installing the ring gear, the appropriate ring gear should be determined according to the tire model or parameters and the diameter of the wheel hub. It is recommended that you do not choose a copycat axle when choosing an axle for a trailer, so that the ring gear cannot be installed.
Precautions:
1. When the ring gear is installed, it should be fully heated to about 180°C-200°C for 5-10 minutes, and then the ring gear should be assembled with the hub.
2. Make sure the gears are in place when installing.
3. It is forbidden to impact the ring gear with metal objects, so as to avoid damage to the ring gear and affect the accuracy of the sensor signal.

Step 2: Sensor installation
The ABS wheel speed sensor is clamped by the WABCO bushing, loaded into the clamping body, and installed on the axle. It is usually fixed on the axle by welding.
After the sensor holder is fixed, the sensor and the ring gear are vertically aligned. Push the sensor to contact with the ring gear, the gap between the end jump of the ring gear and the wheel bearing will automatically push the sensor away, so that a gap of less than 0.7mm is formed between the sensor and the ring gear.
Precautions:
1. Be sure to disconnect the main power supply of the vehicle during welding operations.
2. Do not knock the sensor when installing the sensor. Avoid damaging the sensor.
3. Ensure that the sensor is clean to avoid contamination.

Copyright © 2022 Shandong Yuncheng Yongxing Trailer Manufacturing Co., Ltd.   SEO Tag